High Torque Low Rpm Planetary Gear Motor 56mm 12V

Higher Torque Low Rpm Planetary Equipment Motor 56mm 12V

 Gearbox knowledge:

Numero di fasi	riduzione in 1 fase	2 levels reduction	riduzione in tre fasi	four levels reduction	5 phases reduction
Rapporto di riduzione	three.seven,5.two	13.seven,19.2,26.9	50.nine,seventy one.two,99.five,139	188,264,369,516,721	669,977,1367,1911,2672,3736,
gearbox size ” L” mm	26.4	32.6	38.9	45.three	52,5
Max.Running torque	three.0Kgf · cm	six.0Kgf · cm	eight.0Kgf · cm	12.0Kgf · cm	20Kgf · cm
Max. Equipment breaking torque	nine.0Kgf · cm	eighteen.0Kgf · cm	24Kgf · cm	36Kgf · cm	60Kgf · cm
Max. Gearing efficiency	novanta%	ottantuno%	73%	65%	fifty nine%

Motor info:
 

Motor name	Tensione nominale	Nessun gradino		Coppia di carico				Coppia di stallo
		Recente	Ritmo	Attuale	Velocità	Coppia	Potenza di uscita	Coppia	Attuale
		Unione delle Nazioni Unite	r/min	Unione delle Nazioni Unite	r/min	gf · cm	W	gf · cm	Unione delle Nazioni Unite
TG-38123400	dodici	≤40	3400	≤180	2500	40	1.	centosessanta	720
TG-38124500	dodici	≤50	4500	≤350	3300	sessanta	2.	210	1400
TG-38126000	12	≤70	6000	≤720	4500	ottanta	tre sei	300	2800
TG-38243000	24	≤15	3000	≤80	2200	40	.9	centoquaranta	320
TG-38244500	24	≤25	4500	≤180	3300	60	due.	200	730
TG-38246700	24	≤45	6700	≤360	4500	80	tre sei	trecento	1400
1,This table lists some motors parameters, other individuals make sure you refer to particular parameters of tg-38-one.htm. 2,Afier connecting motor and gearbox which is named gearmotor the output torque:motor torque X reduction ratio X        gearing efficiencyoutput velocity:motor speed / reduction ratio.

Notice:

 1, Gearmotor named methods: e . g . PG36M528123000-99.5K    Motor please refer to the motor information TG-38123000.
          Gearbox please refer to gearbox info reduction ratio99.five .Relevant to gearmotor output velocity and torque please
          refer to motor info.
   2, Motor can be mounted wiht magnetic encorder. encorder parameters you should refer to me-32.htm.
   3,CZPT output shaft after lowering: dia8.0mm. other measurements of then output shaft can make as client request.
   4,Chart only for reference,items shall prevail the entity.

Firm Introduction