“H” CLASS Refuse Drag Chains
“H” CLASS Refuse Drag Chains is used for conveying sawdust,wood chips, pulp, garbage, tankage, ashes, and other abrasive waste materials through either wooden or steel troughs. Because of its large, wide opening area, “H” CLASS Refuse Drag Chain provides sizeable carrying capacity when operated at moderate speeds.
각 배럴의 CZPT 면은 평평하여 트로프를 따라 재료를 밀어내는 넓은 면적을 제공하고 체임이 재료 위로 넘어가지 않도록 합니다. 배럴의 둥근 안쪽 면은 스프로킷과의 접촉을 최적화하도록 세심하게 설계되었습니다. 사이드바는 마모 방지 슈로 보강되어 있습니다.
링크에 추가적인 마모 방지면과 강성을 제공합니다. 각 사이드바의 수직 부재는 링크의 강성을 높이고 핀의 손상을 방지합니다.
“H”CLASS Refuse Drag Chain is CZPT in HZPT Promal or Duramal with a tensile strength range of 36,400 to 52,000 pounds. This rugged working chain is CZPT in a pitch range of 5.000 to 8.000 inches. Each link is produced in accordance with manufacturer’s standards and may be interchanged with links made by other chain manufacturers. “H”CLASS Refuse Drag Chain is CZPT in riveted construction only. Grease chambers, cored into each link’s barrel, hold grease which lubricates pins.
Wide faced sprockets, either of machined or cast steel, are recommended for”H” class Refuse Drag Chain operation. CZPT s should always be run in the direction of the closed barrel.
관련 상품
회사 프로필